This Roller Stand is pretty unique in that it uses an AB Dick 360 Form Roller from a printing press for its feature part. This form roller is hard rubber with bearing inserts on each side. It is the best solution ever for this application. Then, rather than using a wood base, we use 2" square tubing with 5/32" walls with a 1.5 inch inside telescoping feature for raising and lowering. To keep things tight at your chosen height, 2 1/2" fine thread hold-down bolts cinch down to hold everything solidly in place.

The entire picture gallery can be found here: Picture Gallery
The entire instruction on how to build and install this yourself: Instruction Document

The build instruction contains everything you need. We encourage you to build it yourself, however, if you can't do it, email deve@speedprint.com and we will get this built for you. If you have any questions or concerns, we are here to help. Either email Deve, or go to forums.devestechnet.com and join in on the conversation. When you are ready for the roller, we will try and help you with that too!